Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 713)

Brocade Network Advisor IP User Manual 661
53-1003153-01
Virtual FCoE port configuration
17
Virtual FCoE port configuration
The virtual FCoE port has the following configuration features:
• Displays the virtual FCoE ports on each of the DCB devices, which provides the Ethernet with
bridging capability
• One-to-one mapping of FCoE ports with 10 Gbps Ethernet ports
• Option to enable or disable the virtual FCoE ports
• Option to view the end devices connected to a virtual FCoE port
Viewing virtual FCoE ports
Configuration of virtual FCoE ports requires installation of the FCoE license on the switch.
NOTE
For Network OS switches running the Network OS version 3.0 and later, the Management application
retrieves all dynamically and statically bonded virtual FCoE ports in the virtual FCoE port pool and
displays them. If there are no bonded virtual FCoE ports on any cluster member, then the cluster is
not displayed.
The physical port and LAG details are displayed in the Switch Port column in the following
circumstances:
• There is a dynamic binding between the virtual FCoE port and the physical port or LAG.
• There is a static binding between the virtual FCoE port and the physical port or lag and there
are end devices connected to it.
To view the virtual FCoE ports, complete the following steps:
1. Select Configure > FCoE from the menu bar.
or
Right-click the DCB device and select FCoE.
The FCoE Configuration dialog box displays.
2. Select the Virtual FCoE Ports tab.
The Virtual FCoE Ports tab displays, as shown in Figure 261 .