Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 234)

180 Brocade Network Advisor IP User Manual
53-1003153-01
Software Configuration
5
The built-in SCP/SFTP servers use the port 22 by default.
To view the port status for the FTP and SCP/SFTP servers, refer to “Viewing port status” on
page 12.
Accessing the FTP server folder
Choose from one of the following options to access the FTP server folder:
• To access the internal FTP folder, select Monitor > Techsupport > View Repository.
• To access the external FTP folder, type the following in a browser window:
ftp://Username@External_FTP_Server_IP_Address
(for example, ftp://[email protected]) and press Enter. Type your password in the pop-up
window and press Enter. The external FTP folder displays.
Configuring an internal FTP server
To configure the internal FTP server settings, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select FTP/SCP/SFTP in the Category list.
The FTP/SCP/SFTP pane displays ( Figure 71 ).
FIGURE 71 Options dialog box (FTP/SCP/SFTP pane)
3. Select the Use built-in FTP/SCP/SFTP Server option to use the default built-in FTP server.
All active fields are mandatory. The default user name is admin. The full path to the built-in FTP
directory displays in the Root Directory field.
4. Select the Built-in FTP Server check box.
5. Change your password by entering a new password in the Password and Confirm Password
fields.
The default password is passw0rd (where 0 is a zero).
6. Click Test to test the FTP server.
An “FTP Server running successfully” or an error message displays.
If you receive an error message, make sure your credentials are correct, the server is running,
the remote directory path exists, and you have the correct access permission; then try again.
7. Click Apply or OK to save your work.