Configuring a user-defined sflow, Performance monitor – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 434
382
Brocade Network Advisor IP User Manual
53-1003153-01
User-defined performance monitors
8
•
To specify a color based on values of red, green, and blue, click the RGB tab. Specify
the values for red (0 through 255), green (0 through 255), blue (0 through 255), and
alpha (0 through 255).
•
To specify a color based on values of cyan, magenta, yellow, and black, click the CMYK
tab. Specify the values for cyan (0 through 255), magenta (0 through 255), yellow (0
through 255), black (0 through 255), and alpha (0 through 255).
•
To reset to the default color, click Reset.
9. (Time series monitors only) Add targets for the monitor by clicking Add and completing the
steps in
“Adding targets to a user-defined performance monitor”
Remove targets from the monitor by selecting one or more targets in the Targets list and
clicking Remove.
10. Click OK on the Add Performance Dashboard Monitor dialog box.
The Customize Dashboard dialog box displays with the new monitor in the Performance
Monitors list.
11. Click OK on the Customize Dashboard dialog box.
The new performance monitors display at the bottom of the dashboard.
Accessing additional data from user-defined port performance monitors
•
In a Distribution monitor, double-click a percentage range to navigate to the Measure_Type
Distribution Data Details dialog box. For more information, refer to
“Viewing port distribution data details”
•
In a Top N or Bottom N monitor, double-click a row or right-click a row and select Show
Graph/Table to navigate to the Historical Graphs/Tables dialog box for the selected measures.
For more information, refer to
•
In a Top N sFlow monitor, double-click a device row to navigate to the sFlow Monitor Report
dialog box. For more information, refer to
“Interpreting an sFlow traffic report”
Configuring a user-defined sFlow performance monitor
For creating a user-defined dashboard, refer to
“Creating a user-defined dashboard”
and perform the following steps to configure a user-defined sFlow performance monitor.
1. Click the Customize Dashboard icon.
The Customize Dashboard dialog box displays.
2. Click the Performance tab.
3. Click Add.
The Add Performance Dashboard Monitor dialog box displays.
4. Select the type of monitor you are creating from the Monitor Type - Top N sFlows area:
•
MAC
•
IP
•
VM
•
VLAN