Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 693)

Brocade Network Advisor IP User Manual 641
53-1003153-01
Network OS switches in VCS mode
17
Network OS switches in VCS mode
For a Network OS switch in VCS mode or standalone mode, you can use the management
application to perform the following tasks:
• View Network OS switches, ports, LAGs, and vLAGs and their basic configuration details and
detailed DCB configurations.
• Enable and disable ports, LAGs, and vLAGs.
• View real-time performance graphs.
• View historical graphs and reports.
• View profiled port, LAG, and vLAG configurations.
• View the list of virtual FCoE ports.
• Enable, disable, and view Connected End Device details for the listed virtual FCoE ports.
• Launch the VLAN Manager.
• Launch the Access Control List (ACL) Manager.
NOTE
Network OS switches in standalone mode do not support FCoE login group management or virtual
FCoE port management.
NOTE
Network OS switches in VCS mode do not support FCoE login group management.
Fabric OS Converged 10 GbE switch
module for IBM BladeCenter with
Fabric OS 6.3.1_cee and 6.3.1_dcb Allows Fabric OS Converged 10 Gbe
switch module for IBM BladeCenter
with Fabric OS 6.3.1_cee, Fabric OS
6.3.1_dcb.
Allows Dell M8428-k switch with
Fabric OS 6.3.1_dell, Fabric OS
6.3.1_dcb.
Both source and target switches
must support the FCoE map and
VLAN classifiers.
Dell M8428-k switch with Fabric OS
6.3.1_dell and 6.3.1_dcb Allows Fabric OS Converged 10 Gbe
switch module for IBM BladeCenter
with Fabric OS 6.3.1_cee, Fabric OS
6.3.1_dcb.
Allows Dell M8428-k switch with
Fabric OS 6.3.1_dell, Fabric OS
6.3.1_dcb.
Both source and target switches
must support the FCoE map and
VLAN classifiers.
TABLE 62 Source to target switch Fabric OS version compatibility (Continued)
Source Fabric OS version and device Target Fabric OS version supported Comments