Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 782)

730 Brocade Network Advisor IP User Manual
53-1003153-01
Layer 3 access control list policy
19
Deleting a network group
NOTE
You cannot delete a network group that is in use.
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 700
• “Editing a standard L3 ACL configuration” on page 702
• “Copying a standard L3 ACL configuration” on page 703
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
To delete a network group, complete the following steps.
1. Click the Network Groups tab.
2. Select one or more network groups that you want to delete in the List of Network Groups table
and click Delete.
3. Click Yes on the confirmation message.
4. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Service configuration
The Management application allows you to filter traffic from a specific service source or destination
port. A service is either TCP or UDP port. Use the following procedures to configure a service:
• “Viewing existing services” on page 731
• “Creating a service” on page 732
• “Editing a service” on page 733
• “Copying a service” on page 733
• “Deleting a service” on page 734