Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 110)

56 Brocade Network Advisor IP User Manual
53-1003153-01
Default IP user credentials
3
• Select the SNMPv3 read-write credentials you want to delete in the Selected SNMPv3
Read-Write Credentials list and click the left arrow button.
• Select the SNMPv1 or SNMPv2c read-write community string you want to delete in the
Selected Read-Write Community Strings list and click the left arrow button.
5. Click Apply to save your work.
6. Click Close to close the Discover Setup - IP dialog box.
7. Click Yes on the confirmation message.
Default IP user credentials
The Management application uses default user names and passwords to access devices when
contacting these devices through the command line interface (CLI) on the network. You can enter a
list of default names and passwords in the Management application before running discovery.
Discovery uses this list to contact devices to determine the correct user name and password for the
device. The first time discovery contacts a device, the Management application enters the default
names and passwords for the device into the Management application database. This feature
saves you the trouble of entering authentication passwords for every newly discovered device.
NOTE
Discovery does not remove an invalid user name or password from the device information unless it
is able to replace it with a valid one.
The Management application groups default user names and passwords by the following password
types:
• Read/Write Login Prompt — The login prompt the device uses when logging in by Telnet or CLI
to the device.
• Read/Write Enable Prompt — The enable prompt the device uses in CLI mode to go to device
enable mode.
• Enable Super User — The super user enable password configured on the device for Telnet
login. You can configure the super user enable password by using the enable
super-user-password CLI command. The super user enable password can be used to
authenticate users with the super user privilege configured on the device.
You can define more than one password for each password type. Discovery uses the passwords in
the order they are listed when it probes the devices.
Adding user credentials
To add default user names and passwords, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Global Settings tab.
3. Click the Default Passwords tab.