Configuration policy manager scheduling, Configuration policy manager scheduling 3, Configuring a one-time – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 1295: Configuration policy manager schedule, Figure 529
Brocade Network Advisor IP User Manual
1243
53-1003153-01
Configuration policy manager scheduling
37
FIGURE 529
Add Configuration Policy Manager dialog box, Management Checks tab
a. Select the Management Checks tab.
b. Select the Check to see if the server backup is enabled and working check box to
determine the following configurations:
•
Backup enabled for the Management application server.
•
Backup output directory is accessible and writable.
This policy only applies to scheduled backup, not manual (on demand) backup.
For more information about this check and a fix for rule violations, refer to
10. Click OK on the Add Monitor dialog box.
The Configuration Policy Manager dialog box displays with the new configuration policy
manager in the Monitors list.
11. Click Close on the Configuration Policy Manager dialog box.
Configuration policy manager scheduling
You can schedule a configuration policy manager to run automatically. For step-by-step
instructions, refer to the following procedures:
•
“Configuring a one-time configuration policy manager schedule”
•
“Configuring an hourly configuration policy manager schedule”
•
“Configuring a daily configuration policy manager schedule”
•
“Configuring a weekly configuration policy manager schedule”
•
“Configuring a monthly configuration policy manager schedule”
Configuring a one-time configuration policy manager schedule
To configure a one-time schedule, complete the following steps.
1. Select One Time from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
4. Click OK on the Schedule Properties dialog box.
To finish configuring the configuration policy manager, return to