Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 787)

Brocade Network Advisor IP User Manual 735
53-1003153-01
Layer 3 access control list policy
19
Service group configuration
The Management application allows you to filter traffic from a specific service group. A service
group is made up of one or more port ranges, services, or service groups. Use the following
procedures to configure a service group:
• “Viewing existing service groups” on page 735
• “Creating a service group” on page 736
• “Editing a service group” on page 737
• “Copying a service group” on page 738
• “Deleting a service group” on page 739
Viewing existing service groups
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an IPv6 L3 ACL configuration” on page 711
• “Copying an IPv6 L3 ACL configuration” on page 712
To view all existing service groups, complete the following steps.
1. Click the Service Groups tab.
FIGURE 288 Service dialog box, Service Group tab
2. Review the List of Service Groups table:
• Name — The service group name.
• Port Range — The range (1 — 65535) of port numbers.
• Services — The name of each service in the service group.
• Service Groups — The name of each service group in the service group.