Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 515)

Brocade Network Advisor IP User Manual 463
53-1003153-01
Editing a Call Home center
11
13. Click OK.
The Call Home dialog box displays with the Call Home center you edited highlighted in the Call
Home Centers list.
14. Click OK to close the Call Home dialog box.
Editing the HP LAN Call Home center
To edit an HP LAN Call Home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the HP LAN Call Home center you want to edit in the Call Home Centers list.
3. Click Edit Centers (beneath the Call Home Centers list).
The Configure Call Home Center dialog box displays ( Figure 198 ).
FIGURE 198 Configure Call Home Center dialog box (HP LAN option)
4. Make sure the HP LAN Call Home center type displays in the Call Home Centers list.
If the Call Home center type is incorrect, select the correct type from the list.
5. Select the Enable check box to enable this Call Home center.
6. Enter the IP address of the Call Home center in the Service Gateway field.
The default is 2069.
7. Enter the port number of the Call Home center in the Port field.