Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 125)

Brocade Network Advisor IP User Manual 71
53-1003153-01
IP discovery profiles
3
Adding CIDR subnet addresses
To add CIDR subnet addresses (IPv4 and IPv6), complete the following steps.
1. Select CIDR Subnet from the Entry Type list.
FIGURE 22 Include CIDR Subnet
2. Enter the IP address in the IP Address field.
3. Enter the number of subnet mask bits in the Subnet Mask Bits field.
For IPv4, the number of subnet mask bits is from 0 through 32.
For IPv6, the number of subnet mask bits is from 0 through128.
4. To exclude an address range using the CIDR Subnet format, refer to “Excluding CIDR subnet
addresses” on page 72.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 70.
Adding subnet addresses
To add subnet addresses (IPv4 only), complete the following steps.
1. Select Subnet from the Entry Type list.
FIGURE 23 Include Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask in the Subnet Mask field.
4. To exclude an address range using the Subnet format, refer to “Excluding subnet addresses”
on page 73.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 70.