Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 780)

728 Brocade Network Advisor IP User Manual
53-1003153-01
Layer 3 access control list policy
19
5. To edit an address range to the network group, complete the following steps.
a. Select the range you want to edit in the Selected table and click the left arrow button.
b. Change the IP address for the start of the range in the Start field.
c. Change the IP address for the end of the range in the End field.
d. Click the right arrow button to move the address range back to the Selected table.
6. To add an address range to the network group, complete the following steps.
a. Enter an IP address for the start of the range in the Start field.
b. Enter an IP address for the end of the range in the End field.
c. Click the right arrow button to move the address range to the Selected table.
7. To add a network to the network group, complete the following steps.
a. Select one or more networks from the Networks table.
b. Click the right arrow button to move to the Selected table.
8. To add another network group to the network group, complete the following steps.
a. Select one or more network groups from the Network Groups table.
b. Click the right arrow button to move to the Selected table.
9. Click OK on the Edit Network Group dialog box.
The Network dialog box - Network Groups tab displays.
10. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Copying a network group
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 700
• “Editing a standard L3 ACL configuration” on page 702
• “Copying a standard L3 ACL configuration” on page 703
• “Creating an extended L3 ACL configuration” on page 704
• “Editing an extended L3 ACL configuration” on page 706
• “Copying an extended L3 ACL configuration” on page 707
To copy a network group, complete the following steps.
1. Click the Network Groups tab.
2. Select the network group you want to copy in the List of Network Groups table and click
Duplicate.
The Duplicate Network Group dialog box displays.
3. Enter a name for the network group in the Group Name field.
4. To remove a component from the network group, select the component in the Selected table
and click the left arrow button.