Deleting a service – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 786
734
Brocade Network Advisor IP User Manual
53-1003153-01
Layer 3 access control list policy
19
4. Select one of the following protocol options:
•
TCP
•
UDP
5. Enter a port number in the Port field.
6. Click OK on the Duplicate Service dialog box.
7. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to
Deleting a service
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an IPv6 L3 ACL configuration”
•
“Copying an IPv6 L3 ACL configuration”
To delete one or more services, complete the following steps.
1. Click the Services tab.
2. Select one or more services that you want to delete and click Delete.
3. Click Yes on the confirmation message.
4. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to