Deleting a policy or rule, Deploying a pbr policy on demand, Deploying – Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 723: A pbr policy on demand
Brocade Network Advisor IP User Manual
671
53-1003153-01
Policy-based routing
18
The Deploy to Products - PBR dialog box displays. To deploy the PBR policy, refer to
“Saving a PBR policy deployment”
on page 672, or
“Scheduling a PBR policy deployment”
Deleting a policy or rule
1. Select an Ethernet router, Ethernet core router, or Ehternet Backbone router product and select
Configure > Policy Based Routing.
The Product_Name PBR Configuration dialog box displays.
2. Select the policy or rule you want to delete in the Policy and Rules table and click Delete.
A confirmation message displays. Click Yes to delete the selected rule or the selected policy
and all associated rules.
3. Click OK on the Product_Name PBR Configuration dialog box.
The Deploy to Products - PBR dialog box displays. To deploy the PBR policy, refer to
“Saving a PBR policy deployment”
on page 672, or
“Scheduling a PBR policy deployment”
Deploying a PBR policy on demand
To deploy a PBR policy immediately, complete the following steps.
1. Choose one of the following options:
•
Deploy now — Select to deploy the configuration immediately on the product or port
without saving the deployment definition.
•
Save and deploy now — Select to deploy the configuration immediately on the product or
port and save the deployment definition for future deployment.
2. Select one of the following save configuration options:
•
Save to running — Select to update the running configuration; however, the deployment is
not saved to the product’s flash memory.
•
Save to running and startup — Select to update the running configuration as well as save
the deployment configuration to the product’s flash memory. Selecting this option is the
equivalent to a write memory command on the product CLI.
•
Save to running and startup then reboot — Select to update the running configuration,
save the deployment configuration to the product’s flash memory, and reboot the product.
Selecting this option is the equivalent to entering a write memory and a reload command
on the product CLI.
3. Enter a name for the deployment in the Name field.
4. Enter a description for the deployment in the Description field.
5. Click the Snapshot Use check box and click the ellipsis button to select the product monitoring
template.
NOTE
The Snapshot Use check box is only available for IronWare products.
The Pre-Post Snapshot Properties dialog box displays.