Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 192)

138 Brocade Network Advisor IP User Manual
53-1003153-01
Server Data backup
5
3. Select the Enable Backup check box.
4. Click Apply or OK.
Disabling backup
Backup is enabled by default. If you want to stop the backup process, you need to disable backup.
To disable the backup function, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Server Backup in the Category list.
3. Clear the Enable Backup check box.
4. Click Apply or OK.
Viewing the backup status
The Management application enables you to view the backup status at a glance by providing a
backup status icon on the Status Bar. The following table illustrates and describes the icons that
indicate the current status of the backup function.
Changing the backup interval
When the backup feature is enabled, your SAN is protected by automatic backups. The backups
occur every 24 hours by default. However, you can change the interval at which backup occurs.
NOTE
Do NOT modify the backup.properties file.
To change the backup interval, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Server Backup in the Category list.
TABLE 17 Backup status
Icon Description
Backup in Progress — displays the following tooltip: “Backup started at hh:mm:ss, in progress...
XX directories are backed up.”
Countdown to Next Scheduled Backup — displays the following tooltip: “Next backup scheduled
at hh:mm:ss.”
Backup Disabled — displays the following tooltip: “Backup is disabled.”
Backup Failed — displays the following tooltip: “Backup failed at hh:mm:ss mm/dd/yyyy.”