Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 763)

Brocade Network Advisor IP User Manual 711
53-1003153-01
Layer 3 access control list policy
19
The new ACL displays in the ACLs list.
17. To set the configuration type and operations, refer to “Configuring the ACL configuration type
and operations” on page 716.
18. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 716.
19. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To deploy the configuration, refer to
“Security configuration deployment” on page 748.
Editing an IPv6 L3 ACL configuration
To edit an IPv6 L3 ACL configuration, complete the following steps.
1. Select an Ethernet router product and select Configure > Security > L3 ACL > Product.
The Device_Name - L3 ACL Configuration dialog box displays.
2. Select the ACL configuration you want to copy in the ACLs list and click Edit.
The Edit - L3 ACL (IPv 6) Configuration dialog box displays.
3. To add a new ACL entry, repeat step 4 through step 11 in “Creating an extended L3 ACL
configuration” on page 704.
4. To edit an existing ACL entry, select the ACL you want to edit in the ACL Entries list, click the left
arrow button and repeat step 4 through step 11 in “Creating an extended L3 ACL
configuration” on page 704.
5. To delete an existing ACL entry, select the ACL you want to delete in the ACL Entries list and
click the left arrow button.
6. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
7. View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking
View.
The L3 ACL Advanced Settings dialog box displays.
8. Click Close on the L3 ACL Advanced Settings dialog box to close.
9. Click OK on the Edit - L3 ACL (IPv 6) Configuration dialog box.
The updated ACL displays in the ACLs list.
10. To set the configuration type and operations, refer to “Configuring the ACL configuration type
and operations” on page 716.
11. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 716.
12. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To deploy the configuration, refer to
“Security configuration deployment” on page 748.