Brocade Network Advisor IP User Manual v12.3.0 User Manual
Page 867
Brocade Network Advisor IP User Manual
815
53-1003153-01
Configuring a switch for FICON operation
22
•
To manually configure SNMP for discovery, select Manual to activate the SNMP tab, then
select the SNMP tab. Fill out the fields as required.
.
FIGURE 312
Add Fabric Discovery dialog box (SNMP tab)
Refer to the “SAN discovery overview” section in
for more information
on using these dialog boxes.
7. Add all required licenses to the switch using the following steps:
a. Select a discovered switch from the Product List panel, and then select Element Manager
> Admin.
The Web Works Switch Administration window displays.
b. Select the License tab and click Add.
The Add License dialog box displays.
c. Past or enter the license key in the License Key field.
d. Click Add License.
e. Repeat steps b through d for additional licenses.
f.
Click Refresh to display new licenses in the License tab.
8. As an optional step, manage switch users by selecting the User tab on the Web Works Switch
Administration window. Use this tab to add users, change passwords, or perform other steps to
manage switch users.
NOTE
If you change the password for a user that was used for Management application discovery,
you must delete the switch from the Discover Fabrics dialog box, and then discover the switch
again with the new login credentials.
9. To download firmware to the switch, select Configure > Firmware Management from the SAN
tab on the Management application window as shown in