Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 1247)

Brocade Network Advisor IP User Manual 1195
53-1003153-01
Chapter
36
Power Center
In this chapter
• Power center overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1195
• Data monitoring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1196
• PoE power on demand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1205
• Schedule PoE power deployment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1207
• PoE thresholds. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1216
• Viewing PoE performance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1223
Power center overview
NOTE
Power over Ethernet (PoE) is only supported on IronWare PoE-capable products.
PoE products enable you to safely pass electrical power, along with data, on Ethernet cabling. The
power comes from a power supply within a PoE-capable networking device (such as an Ethernet
switch). For more information about PoE, refer to the IronWare Ethernet switch Configuration
Guide.
You can use Power Center to perform the following functions on PoE-capable products:
• Determine how much poweris consumed by devices (phones and so on) connected to the
product.
• Create power thresholds.
• Monitor power thresholds.
• Power up ports.
• Power down ports.
• Determine PoE capacity.
• Determine PoE allocation.