Configuring rmon events, Figure 270 s – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 1004
954
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Remote Monitoring
42
FIGURE 270
Showing Configured RMON Alarms
Configuring RMON Events
Use the Administration > RMON (Configure Global - Add - Event) page to set the action to take when
an alarm is triggered. The response can include logging the alarm or sending a message to a trap
manager. Alarms and corresponding events provide a way of immediately responding to critical
network problems.
CLI References
•
Command Usage
•
If an alarm is already defined for an index, the entry must be deleted before any changes can
be made.
•
One default event is configured as follows:
event Index = 1
Description: RMON_TRAP_LOG
Event type: log & trap
Event community name is public
Owner is RMON_SNMP
Parameters
These parameters are displayed:
•
Index – Index to this entry. (Range: 1-65535)
•
Type – Specifies the type of event to initiate:
•
None – No event is generated.
•
Log – Generates an RMON log entry when the event is triggered. Log messages are
processed based on the current configuration settings for event logging (see
•
Trap – Sends a trap message to all configured trap managers (see
•
Log and Trap – Logs the event and sends a trap message.