Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 616)

566 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
OAM Commands
26
Example
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam link-monitor frame threshold 5
Console(config-if)#
efm oam link-monitor frame window
This command sets the monitor period for errored frame link events. Use the no form to restore the
default setting.
Syntax
[no] efm oam link-monitor frame window size
size - The period of time in which to check the reporting threshold for errored frame link
events. (Range: 10-65535 units of 10 milliseconds)
Default Setting
10 (units of 100 milliseconds) = 1 second
Command Mode
Interface Configuration
Command Usage
If this feature is enabled, an event notification message is sent if the threshold specified by the
efm oam link-monitor frame threshold command ( page 565 ) is reached or exceeded within the
period specified by this command. The Errored Frame Event TLV includes the number of errored
frames detected during the specified period.
Example
This example set the window size to 5 seconds.
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam link-monitor frame window 50
Console(config-if)#
efm oam mode
This command sets the OAM mode on the specified port. Use the no form to restore the default
setting.
Syntax
efm oam mode {active | passive}
no efm oam mode
active - All OAM functions are enabled.
passive - All OAM functions are enabled, except for OAM discovery, and sending loopback
control OAMPDUs.
Default Setting
Active