Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 867)

Brocade 6910 Ethernet Access Switch Configuration Guide 817
53-1002581-01
Configuring Telephony OUI
40
Configuring Telephony OUI
VoIP devices attached to the switch can be identified by the vendor’s Organizational Unique
Identifier (OUI) in the source MAC address of received packets. OUI numbers are assigned to
vendors and form the first three octets of device MAC addresses. The MAC OUI numbers for VoIP
equipment can be configured on the switch so that traffic from these devices is recognized as VoIP.
Use the Traffic > VoIP (Configure OUI) page to configure this feature.
CLI References
• “Configuring Voice VLANs” on page 411
Parameters
These parameters are displayed:
• Telephony OUI – Specifies a MAC address range to add to the list. Enter the MAC address in
format 01-23-45-67-89-AB.
• Mask – Identifies a range of MAC addresses. Selecting a mask of FF-FF-FF-00-00-00 identifies
all devices with the same OUI (the first three octets). Other masks restrict the MAC address
range. Selecting FF-FF-FF-FF-FF-FF specifies a single MAC address.
(Default: FF-FF-FF-00-00-00)
• Description – User-defined text that identifies the VoIP devices.
Interface
To configure MAC OUI numbers for VoIP equipment:
1. Click Traffic, VoIP.
2. Select Configure OUI from the Step list.
3. Select Add from the Action list.
4. Enter a MAC address that specifies the OUI for VoIP devices in the network.
5. Select a mask from the pull-down list to define a MAC address range.
6. Enter a description for the devices.
7. Click Apply.
FIGURE 158 Configuring an OUI Telephony List