Configuring an extended ipv4 acl, Figure 202 confi – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 913
Brocade 6910 Ethernet Access Switch Configuration Guide
863
53-1002581-01
Access Control Lists
41
Interface
To add rules to a Standard IPv4 ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select IP Standard from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the address type (Any, Host, or IP).
8. If you select “Host,” enter a specific address. If you select “IP,” enter a subnet address and the
mask for an address range.
9. Click Apply.
FIGURE 202
Configuring a Standard IPv4 ACL
Configuring an Extended IPv4 ACL
Use the Security > ACL (Configure ACL - Add Rule - IP Extended) page to configure an Extended IPv4
ACL.
CLI References
•
“permit, deny (Extended IPv4 ACL)”
•
•