Ping – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 645

Advertising
background image

Brocade 6910 Ethernet Access Switch Configuration Guide

595

53-1002581-01

IPv4 Interface

29

ping

This command sends (IPv4) ICMP echo request packets to another node on the network.

Syntax

ping host [count count] [size size]

host - IP address or alias of the host.

count - Number of packets to send. (Range: 1-16)

size - Number of bytes in a packet. (Range: 32-512)
The actual packet size will be eight bytes larger than the size specified because the router
adds header information.

Default Setting

count: 5
size: 32 bytes

Command Mode

Normal Exec, Privileged Exec

Command Usage

•

Use the ping command to see if another site on the network can be reached.

•

The following are some results of the ping command:

•

Normal response - The normal response occurs in one to ten seconds, depending on
network traffic.

•

Destination does not respond - If the host does not respond, a “timeout” appears in ten
seconds.

•

Destination unreachable - The gateway for this destination indicates that the destination is
unreachable.

•

Network or host unreachable - The gateway found no corresponding entry in the route
table.

•

When pinging a host name, be sure the DNS server has been defined (

page 576

), and host

name-to-address translation enabled (

page 574

). If necessary, local devices can also be

specified in the DNS static host table (see

page 576

).

Example

Console#ping 10.1.0.9

Type ESC to abort.

PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds

response time: 10 ms

response time: 10 ms

response time: 10 ms

response time: 10 ms

response time: 0 ms

Ping statistics for 10.1.0.9:

5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)

Approximate round trip times:

Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms

Console#

Advertising