Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 110)

60 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
System Status
5
• Use this command in conjunction with the show startup-config command to compare the
information in running memory to the information stored in non-volatile memory.
• This command displays settings for key command modes. Each mode group is separated by “!”
symbols, and includes the configuration mode command, and corresponding commands. This
command displays the following information:
• MAC address for the switch
• SNMP community strings
• Users (names, access levels, and encrypted passwords)
• VLAN database (VLAN ID, name and state)
• VLAN configuration settings for each interface
• Multiple spanning tree instances (name and interfaces)
• Interface settings and VLAN configuration settings for each interface
• IP address configured for management VLAN
• Any configured settings for the console port and Telnet
Example
Console#show running-config
Building startup configuration. Please wait...
!<stackingDB>00</stackingDB>
!<stackingMac>01_00-e0-0c-00-00-fd_00</stackingMac>
!
l2protocol-tunnel tunnel-dmac 01-12-cf-00-00-00
!
snmp-server community public ro
snmp-server community private rw
!
snmp-server enable traps authentication
!
username admin access-level 15
username admin password 7 21232f297a57a5a743894a0e4a801fc3
username guest access-level 0
username guest password 7 084e0343a0486ff05530df6c705c8bb4
enable password level 15 7 1b3231655cebb7a1f783eddf27d254ca
!
vlan database
VLAN 1 name DefaultVlan media ethernet state active
!
spanning-tree mst configuration
!
interface ethernet 1/1
ip igmp max-groups 1023
ip igmp max-groups action deny
.
.
.
!
interface vlan 1
ip address dhcp
!
interface craft
!
line console
!
line vty