Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1051)

Brocade 6910 Ethernet Access Switch Configuration Guide 1001
53-1002581-01
Connectivity Fault Management
42
FIGURE 307 Showing the Link Trace Cache
Displaying Fault Notification Settings
Use the Administration > CFM > Show Information (Show Fault Notification Generator) page to
display configuration settings for the fault notification generator.
CLI References
• “show ethernet cfm fault-notify-generator” on page 559
Parameters
These parameters are displayed:
• MEP ID – Maintenance end point identifier.
• MD Name – Maintenance domain name.
• MA Name – Maintenance association name.
• Highest Defect – The highest defect that will generate a fault alarm.
(This is disabled by default.)
• Lowest Alarm – The lowest defect that will generate a fault alarm 21 .
• Alarm Time – The time a defect must exist before a fault alarm is issued
21
.
• Reset Time – The time after a fault alarm has been issued, and no defect exists, before
another fault alarm can be issued
21
.
Interface
To show configuration settings for the fault notification generator:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Fault Notification Generator from the Action list.
FIGURE 308 Showing Settings for the Fault Notification Generator
21. See “Configuring CFM Maintenance Domains” on page 977.