Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 409)

Brocade 6910 Ethernet Access Switch Configuration Guide 359
53-1002581-01
Chapter
19
ERPS Commands
The G.8032 recommendation, also referred to as Ethernet Ring Protection Switching (ERPS), can
be used to increase the availability and robustness of Ethernet rings.
This chapter describes commands used to configure ERPS.
Configuration Guidelines for ERPS
1. Create an ERPS ring: Create a ring using the erps domain command. The ring name is used as
an index in the G.8032 database.
2. Configure the east and west interfaces: Each node on the ring connects to it through two ring
ports. Use the ring-port command to configure one port connected to the next node in the ring
to the east (or clockwise direction); and then use the ring-port command again to configure
another port facing west in the ring.
TABLE 79 ERPS Commands
Command Function Mode
erps Enables ERPS globally on the switch GC
erps domain Creates an ERPS ring and enters ERPS configuration mode GC
control-vlan Adds a Control VLAN to an ERPS ring ERPS
enable Activates the current ERPS ring ERPS
guard-timer Sets the timer to prevent ring nodes from receiving outdated R-APS messages ERPS
holdoff-timer Sets the timer to filter out intermittent link faults ERPS
major-domain Specifies the ERPS ring used for sending control packets ERPS
meg-level Sets the Maintenance Entity Group level for a ring ERPS
mep-monitor Specifies the CCM MEPs used to monitor the link on a ring node ERPS
node-id Sets the MAC address for a ring node ERPS
non-erps-dev-protect Sends non-standard health-check packets when in protection state ERPS
propagate-tc Enables propagation of topology change messages from a secondary ring to
the primary ring ERPS
ring-port Configures a node’s connection to the ring through the east or west interface ERPS
rpl owner Configures a ring node to be the RPL owner or a non-owner ERPS
wtr-timer Sets timer to verify that the ring has stabilized before blocking the RPL after
recovery from a signal failure ERPS
show erps Displays status information for all configured rings, or for a specified ring PE