Mac- authentication max-mac-count, Clear network-access – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 257

Advertising
background image

Brocade 6910 Ethernet Access Switch Configuration Guide

207

53-1002581-01

Network Access (MAC Address Authentication)

10

mac- authentication max-mac-count

Use this command to set the maximum number of MAC addresses that can be authenticated on a
port via MAC authentication. Use the no form of this command to restore the default.

Syntax

mac-authentication max-mac-count count

no mac-authentication max-mac-count

count - The maximum number of MAC-authenticated MAC addresses allowed.
(Range: 1-1024)

Default Setting

1024

Command Mode

Interface Configuration

Example

Console(config-if)#mac-authentication max-mac-count 32

Console(config-if)#

clear network-access

Use this command to clear entries from the secure MAC addresses table.

Syntax

clear network-access mac-address-table [static | dynamic]

[address mac-address] [interface interface]

static - Specifies static address entries.

dynamic - Specifies dynamic address entries.

mac-address - Specifies a MAC address entry. (Format: xx-xx-xx-xx-xx-xx)

interface - Specifies a port interface.

ethernet unit/port

unit - This is unit 1.

port - Port number. (Range: 1-12)

Default Setting

None

Command Mode

Privileged Exec

Example

Console#clear network-access mac-address-table interface ethernet 1/1

Console#

Advertising