Configuring mvr domain settings, Figure 373 confi, Configuring mvr – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 1133: Domain settings

Advertising
background image

Brocade 6910 Ethernet Access Switch Configuration Guide

1083

53-1002581-01

Multicast VLAN Registration for IPv4

46

Interface

To configure global settings for MVR:

1. Click Multicast, MVR.

2. Select Configure Global from the Step list.

3. Set the status for MVR proxy switching and the robustness value used for report and query

messages.

4. Click Apply.

FIGURE 373

Configuring Global Settings for MVR

Configuring MVR Domain Settings

Use the Multicast > MVR (Configure Domain) page to enable MVR globally on the switch, and select
the VLAN that will serve as the sole channel for common multicast streams supported by the
service provider.

CLI References

“MVR for IPv4”

on page 475

Parameters

These parameters are displayed:

Domain ID– An independent multicast domain. (Range: 1-5)

MVR Status – When MVR is enabled on the switch, any multicast data associated with an MVR
group is sent from all designated source ports, to all receiver ports that have registered to
receive data from that multicast group. (Default: Disabled)

MVR VLAN – Identifier of the VLAN that serves as the channel for streaming multicast services
using MVR. MVR source ports should be configured as members of the MVR VLAN (see

“Adding

Static Members to VLANs”

on page 724), but MVR receiver ports should not be manually

configured as members of this VLAN. (Default: 1)

MVR Running Status – Indicates whether or not all necessary conditions in the MVR
environment are satisfied. Running status is Active as long as MVR is enabled, the specified
MVR VLAN exists, and a source port with a valid link has been configured (see

“Configuring

MVR Interface Status”

on page 1087).

MVR Current Learned Groups – The number of MVR groups currently assigned to this domain.

Advertising