Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 546)

496 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
MVR for IPv6
23
Default Setting
All MVR reports sent upstream use a null source IP address
Command Mode
Global Configuration
Command Usage
All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing Architecture,” using 8
colon-separated 16-bit hexadecimal values. One double colon may be used in the address to
indicate the appropriate number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
Example
Console(config)#mvr6 domain 1 upstream-source-ip 2001:DB8:2222:7223::72
Console(config)#
mvr6 vlan
This command specifies the VLAN through which MVR multicast data is received. Use the no form
of this command to restore the default MVR VLAN.
Syntax
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is received. This is also the
VLAN to which all source ports must be assigned. (Range: 1-4093)
Default Setting
VLAN 1
Command Mode
Global Configuration
Command Usage
MVR source ports can be configured as members of the MVR VLAN using the switchport allowed
vlan command and switchport native vlan command, but MVR receiver ports should not be
statically configured as members of this VLAN.
Example
The following example sets the MVR VLAN to VLAN 1:
Console(config)#mvr6 domain 1 vlan 1
Console(config)#