Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 111)

Brocade 6910 Ethernet Access Switch Configuration Guide 61
53-1002581-01
System Status
5
!
end
!
Console#
Related Commands
show startup-config (61)
show startup-config
This command displays the configuration file stored in non-volatile memory that is used to start up
the system.
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show running-config command to compare the
information in running memory to the information stored in non-volatile memory.
• This command displays settings for key command modes. Each mode group is separated by “!”
symbols, and includes the configuration mode command, and corresponding commands. This
command displays the following information:
• MAC address for the switch
• SNMP community strings
• SNMP trap authentication
• Users (names and access levels)
• VLAN database (VLAN ID, name and state)
• Multiple spanning tree instances (name and interfaces)
• Interface settings and VLAN configuration settings for each interface
• IP address for management VLAN
• Any configured settings for the console port and Telnet
Example
Refer to the example for the running configuration file.
Related Commands
show running-config (59)
show system
This command displays system information.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec