Dot1q-tunnel system-tunnel-control, Switchport dot1q-tunnel mode, Switchport dot1q-tunnel – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 439: Mode

Advertising
background image

Brocade 6910 Ethernet Access Switch Configuration Guide

389

53-1002581-01

Configuring IEEE 802.1Q Tunneling

20

dot1q-tunnel system-tunnel-control

This command sets the switch to operate in QinQ mode. Use the no form to disable QinQ operating
mode.

Syntax

[no] dot1q-tunnel system-tunnel-control

Default Setting

Disabled

Command Mode

Global Configuration

Command Usage

QinQ tunnel mode must be enabled on the switch for QinQ interface settings to be functional.

Example

Console(config)#dot1q-tunnel system-tunnel-control

Console(config)#

Related Commands

show dot1q-tunnel

(

393

)

show interfaces switchport (282)

switchport dot1q-tunnel mode

This command configures an interface as a QinQ tunnel port. Use the no form to disable QinQ on
the interface.

Syntax

switchport dot1q-tunnel mode {access | uplink}

no switchport dot1q-tunnel mode

access – Sets the port as an 802.1Q tunnel access port.

uplink – Sets the port as an 802.1Q tunnel uplink port.

Default Setting

Disabled

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

•

QinQ tunneling must be enabled on the switch using the

dot1q-tunnel system-tunnel-control

command before the switchport dot1q-tunnel mode interface command can take effect.

Advertising