Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 549)

Brocade 6910 Ethernet Access Switch Configuration Guide 499
53-1002581-01
MVR for IPv6
23
Default Setting
No receiver port is a member of any configured multicast group.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Multicast groups can be statically assigned to a receiver port using this command. The
assigned address must fall within the range set by the
mvr6 associated-profile command.
• All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing Architecture,” using 8
colon-separated 16-bit hexadecimal values. One double colon may be used in the address to
indicate the appropriate number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
• The MVR VLAN cannot be specified as the receiver VLAN for static bindings.
Example
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/2
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1
Console(config-if)#
show mvr6
This command shows information about MVR domain settings, including MVR operational status,
the multicast VLAN, the current number of group addresses, and the upstream source IP address.
Syntax
show mvr6 [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all MVR domains.
Command Mode
Privileged Exec
Example
The following shows the MVR settings:
Console#show mvr6
MVR6 Proxy Switching : Enabled
MVR6 Robustness Value : 1
MVR6 Domain : 1
MVR6 Config Status : Enabled
MVR6 Running Status : Active
MVR6 Multicast VLAN : 1
MVR6 Upstream Source IP : FF05::25