Snmp-server view – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 168
118
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
SNMP Commands
6
•
The SNMP engine ID is used to compute the authentication/privacy digests from the password.
You should therefore configure the engine ID with the
command before
using this configuration command.
•
Before you configure a remote user, use the
command to specify the
engine ID for the remote device where the user resides. Then use the snmp-server user
command to specify the user and the IP address for the remote device where the user resides.
The remote agent’s SNMP engine ID is used to compute authentication/privacy digests from
the user’s password. If the remote engine ID is not first configured, the snmp-server user
command specifying a remote user will fail.
•
SNMP passwords are localized using the engine ID of the authoritative agent. For informs, the
authoritative SNMP agent is the remote agent. You therefore need to configure the remote
agent’s SNMP engine ID before you can send proxy requests or informs to it.
Example
Console(config)#snmp-server user steve r&d v3 auth md5 greenpeace priv des56 einstien
Console(config)#snmp-server user mark r&d remote 192.168.1.19 v3 auth md5 greenpeace
priv des56 einstien
Console(config)#
snmp-server view
This command adds an SNMP view which controls user access to the MIB. Use the no form to
remove an SNMP view.
Syntax
snmp-server view view-name oid-tree {included | excluded}
no snmp-server view view-name
view-name - Name of an SNMP view. (Range: 1-32 characters)
oid-tree - Object identifier of a branch within the MIB tree. Wild cards can be used to mask
a specific portion of the OID string. (Refer to the examples.)
included - Defines an included view.
excluded - Defines an excluded view.
Default Setting
defaultview (includes access to the entire MIB tree)
Command Mode
Global Configuration
Command Usage
•
Views are used in the
command to restrict user access to specified portions
of the MIB tree.
•
The predefined view “defaultview” includes access to the entire MIB tree.