Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 490)

440 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Quality of Service Commands
22
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police srtcm-color-blind 100000 4000 6000 conform-action
transmit exceed-action 0 violate-action drop
Console(config-pmap-c)#
police trtcm-color
This command defines an enforcer for classified traffic based on a two rate three color meter
(trTCM). Use the no form to remove a policer.
Syntax
[no] police {trtcm-color-blind | trtcm-color-aware}
committed-rate committed-burst peak-rate peak-burst
conform-action transmit
exceed-action {drop | new-dscp}
violate action {drop | new-dscp}
trtcm-color-blind - Two rate three color meter in color-blind mode.
trtcm-color-aware - Two rate three color meter in color-aware mode.
committed-rate - Committed information rate (CIR) in kilobits per second.
(Range: 0-1000000 kbps at a granularity of 64 kbps or maximum port speed, whichever is
lower)
committed-burst - Committed burst size (BC) in bytes.
(Range: 0-16000000 at a granularity of 4k bytes)
peak-rate - Peak information rate (PIR) in kilobits per second. (Range: 0-1000000 kbps at
a granularity of 64 kbps or maximum port speed, whichever is lower)
peak-burst - Peak burst size (BP) in bytes.
(Range: 0-16000000 at a granularity of 4k bytes)
conform-action - Action to take when rate is within the CIR and BP. (Packet size does not
exceed BP and there are enough tokens in bucket BC to service the packet, the packet is
set green.)
exceed-action - Action to take when rate exceeds the CIR but is within the PIR. (Packet size
exceeds BC but there are enough tokens in bucket BP to service the packet, the packet is
set yellow.)
violate-action - Action to take when rate exceeds the PIR. (There are not enough tokens in
bucket BP to service the packet, the packet is set red.)
drop - Drops packet as required by exceed-action or violate-action.
transmit - Transmits without taking any action.
new-dscp - Differentiated Service Code Point (DSCP) value. (Range: 0-63)
Default Setting
None
Command Mode
Policy Map Class Configuration