Configuring telnet settings, Figure 22, Consol – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 718

Advertising
background image

668

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Configuring Telnet Settings

32

Interface

To configure parameters for the console port:

1. Click System, then Console.

2. Specify the connection parameters as required.

3. Click Apply

FIGURE 22

Console Port Settings

Configuring Telnet Settings

Use the System > Telnet menu to configure parameters for accessing the CLI over a Telnet
connection. You can access the onboard configuration program over the network using Telnet (i.e.,
a virtual terminal). Management access via Telnet can be enabled/disabled and other parameters
set, including the TCP port number, time outs, and a password. Note that the password is only
configurable through the CLI.) These parameters can be configured via the web or CLI interface.

CLI References

•

"Line" on page 75

•

"Telnet Server" on page 164

Parameters

The following parameters are displayed:

•

Telnet Status – Enables or disables Telnet access to the switch. (Default: Enabled)

•

TCP Port – Sets the TCP port number for Telnet on the switch. (Default: 23)

•

Max Sessions – Sets the maximum number of Telnet sessions that can simultaneously
connect to this system. (Range: 0-8)

A maximum of eight sessions can be concurrently opened for Telnet and Secure Shell (i.e.,
both Telnet and SSH share a maximum number or eight sessions).

•

Login Timeout – Sets the interval that the system waits for a user to log into the CLI. If a login
attempt is not detected within the timeout interval, the connection is terminated for the
session. (Range: 10-300 seconds; Default: 300 seconds)

Advertising