Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 435)

Brocade 6910 Ethernet Access Switch Configuration Guide 385
53-1002581-01
Configuring VLAN Interfaces
20
switchport native vlan
This command configures the PVID (i.e., default VLAN ID) for a port. Use the no form to restore the
default.
Syntax
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When using Access mode, and an interface is assigned to a new VLAN, its PVID is automatically
set to the identifier for that VLAN. When using Hybrid mode, the PVID for an interface can be
set to any VLAN for which it is an untagged member.
• If acceptable frame types is set to all or switchport mode is set to hybrid, the PVID will be
inserted into all untagged frames entering the ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
vlan-trunking
This command allows unknown VLAN groups to pass through the specified interface. Use the no
form to disable this feature.
Syntax
[no] vlan-trunking
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Use this command to configure a tunnel across one or more intermediate switches which pass
traffic for VLAN groups to which they do not belong.