Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 721)

Brocade 6910 Ethernet Access Switch Configuration Guide 671
53-1002581-01
Displaying Memory Utilization
32
Displaying Memory Utilization
Use the System > Memory Status page to display memory utilization parameters.
CLI References
• "show memory" on page 58
Parameters
The following parameters are displayed:
• Free Size – The amount of memory currently free for use.
• Used Size – The amount of memory allocated to active processes.
• Total – The total amount of system memory.
Interface
To display memory utilization:
1. Click System, then Memory Status.
FIGURE 25 Displaying Memory Utilization
Resetting the System
Use the System > Reset menu to restart the switch immediately, at a specified time, after a
specified delay, or at a periodic interval.
CLI References
• "reload (Privileged Exec)" on page 44
• "reload (Global Configuration)" on page 40
• "show reload" on page 44
Command Usage
• This command resets the entire system.
• When the system is restarted, it will always run the Power-On Self-Test. It will also retain all
configuration information stored in non-volatile memory by the
copy running-config
startup-config command (see "copy" on page 67 ).