Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 449)

Brocade 6910 Ethernet Access Switch Configuration Guide 399
53-1002581-01
Configuring Port-based Traffic Segmentation
20
Console#
show vlan-translation
This command displays the configuration settings for VLAN translation.
Syntax
show vlan-translation [interface interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show vlan-translation
Interface Old VID New VID
--------- ------- -------
Eth 1/ 1 10 100
Console#
Configuring Port-based Traffic Segmentation
If tighter security is required for passing traffic from different clients through downlink ports on the
local network and over uplink ports to the service provider, port-based traffic segmentation can be
used to isolate traffic for individual clients.
Traffic belonging to each client is isolated to the allocated downlink ports. But the switch can be
configured to either isolate traffic passing across a client’s allocated uplink ports from the uplink
ports assigned to other clients, or to forward traffic through the uplink ports used by other clients,
allowing different clients to share access to their uplink ports where security is less likely to be
compromised.
TABLE 90 Commands for Configuring Traffic Segmentation
Command Function Mode
traffic-segmentation Enables traffic segmentation GC
traffic-segmentation session Creates a client session GC
traffic-segmentation
uplink/downlink Configures uplink/downlink ports for client sessions GC
traffic-segmentation
uplink-to-uplink Specifies whether or not traffic can be forwarded between
uplink ports assigned to different client sessions GC
show traffic-segmentation Displays the configured traffic segments PE