Displaying mvr receiver groups, Figure 380 a, Figure 381 s – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 1140

Advertising
background image

1090

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Multicast VLAN Registration for IPv4

46

FIGURE 380

Assigning Static MVR Groups to a Port

To show the static MVR groups assigned to an interface:

1. Click Multicast, MVR.

2. Select Configure Static Group Member from the Step list.

3. Select Show from the Action list.

4. Select an MVR domain.

5. Select the port or trunk for which to display this information.

FIGURE 381

Showing the Static MVR Groups Assigned to a Port

Displaying MVR Receiver Groups

Use the Multicast > MVR (Show Member) page to show the multicast groups either statically or
dynamically assigned to the MVR receiver groups on each interface.

CLI References

“show mvr members”

on page 487

Parameters

These parameters are displayed:

Domain ID – An independent multicast domain. (Range: 1-5)

Group IP Address – Multicast groups assigned to the MVR VLAN.

Advertising