Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 975)

Brocade 6910 Ethernet Access Switch Configuration Guide 925
53-1002581-01
Link Layer Discovery Protocol
42
• Remote Port Auto-Neg Status – Shows whether port auto-negotiation is enabled on a port
associated with the remote system.
• Remote Port MAU Type – An integer value that indicates the operational MAU type of the
sending device. This object contains the integer value derived from the list position of the
corresponding dot3MauType as listed in IETF RFC 3636 and is equal to the last number in the
respective dot3MauType OID.
Port Details – 802.3 Extension Power Information
• Remote Power Class – The port Class of the given port associated with the remote system
(PSE – Power Sourcing Equipment or PD – Powered Device).
• Remote Power MDI Status – Shows whether MDI power is enabled on the given port
associated with the remote system.
• Remote Power Pairs – “Signal” means that the signal pairs only are in use, and “Spare” means
that the spare pairs only are in use.
• Remote Power MDI Supported – Shows whether MDI power is supported on the given port
associated with the remote system.
• Remote Power Pair Controllable – Indicates whether the pair selection can be controlled for
sourcing power on the given port associated with the remote system.
• Remote Power Classification – This classification is used to tag different terminals on the
Power over LAN network according to their power consumption. Devices such as IP telephones,
WLAN access points and others, will be classified according to their power requirements.
Port Details – 802.3 Extension Trunk Information
• Remote Link Aggregation Capable – Shows if the remote port is not in link aggregation state
and/or it does not support link aggregation.
• Remote Link Aggregation Status – The current aggregation status of the link.
• Remote Link Port ID – This object contains the IEEE 802.3 aggregated port identifier,
aAggPortID (IEEE 802.3-2002, 30.7.2.1.1), derived from the ifNumber of the ifIndex for the
port component associated with the remote system. If the remote port is not in link
aggregation state and/or it does not support link aggregation, this value should be zero.
Port Details – 802.3 Extension Frame Information
• Remote Max Frame Size – An integer value indicating the maximum supported frame size in
octets on the port component associated with the remote system.
Interface
To display LLDP information for a remote port:
1. Click Administration, LLDP.
2. Select Show Remote Device Information from the Step list.
3. Select Port, Port Details, Trunk, or Trunk Details.
14 1000BASE-T half duplex mode
15 1000BASE-T full duplex mode
TABLE 174 Remote Port Auto-Negotiation Advertised Capability (Continued)
Bit Capability