Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1005)

Brocade 6910 Ethernet Access Switch Configuration Guide 955
53-1002581-01
Remote Monitoring
42
• Community – A password-like community string sent with the trap operation to SNMP v1 and
v2c hosts.
Although the community string can be set on this configuration page, it is recommended that it
be defined on the SNMP trap configuration page (see
“Setting Community Access Strings” on
page 938) prior to configuring it here. (Range: 1-127 characters)
• Description – A comment that describes this event. (Range: 1-127 characters)
• Owner – Name of the person who created this entry. (Range: 1-127 characters)
Interface
To configure an RMON event:
1. Click Administration, RMON.
2. Select Configure Global from the Step list.
3. Select Add from the Action list.
4. Click Event.
5. Enter an index number, the type of event to initiate, the community string to send with trap
messages, the name of the person who created this event, and a brief description of the event.
6. Click Apply
FIGURE 271 Configuring an RMON Event
To show configured RMON events:
1. Click Administration, RMON.
2. Select Configure Global from the Step list.
3. Select Show from the Action list.
4. Click Event.