Configuring static dns host to address entries, Figure 346 confi – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 1101
Brocade 6910 Ethernet Access Switch Configuration Guide
1051
53-1002581-01
Domain Name Service
45
Configuring Static DNS Host to Address Entries
Use the IP Service > DNS - Static Host Table (Add) page to manually configure static entries in the
DNS table that are used to map domain names to IP addresses.
CLI References
•
•
Command Usage
•
Static entries may be used for local devices connected directly to the attached network, or for
commonly used resources located elsewhere on the network.
Parameters
These parameters are displayed:
•
Host Name – Name of a host device that is mapped to one or more IP addresses.
(Range: 1-127 characters)
•
IP Address – Internet address(es) associated with a host name.
Interface
To configure static entries in the DNS table:
1. Click IP Service, DNS, Static Host Table.
2. Select Add from the Action list.
3. Enter a host name and the corresponding address.
4. Click Apply.
FIGURE 346
Configuring Static Entries in the DNS Table