Interface configuration, In this chapter, Port configuration – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 725: Configuring by port list, Chapter 33, Chapter
Brocade 6910 Ethernet Access Switch Configuration Guide
675
53-1002581-01
Chapter
33
Interface Configuration
In this chapter
This chapter describes the following topics:
•
– Configures connection settings, including auto-negotiation, or manual
setting of speed, duplex mode, and flow control.
•
– Sets the source and target ports for mirroring on the local switch.
•
– Configures mirroring of traffic from remote switches for analysis at a
destination port on the local switch.
•
– Shows Interface, Etherlike, and RMON port statistics in table or chart
form.
•
– Configures statistical sampling for the specified interfaces.
•
– Displays identifying information and functional parameters for
optical transceivers.
•
– Performs cable diagnostics on the specified port.
•
– Configures static or dynamic trunks.
•
– Adjusts the power provided to ports based on the length of the cable used to
connect to other devices.
•
– Configures periodic sampling of traffic flows.
•
– Configures the uplinks and down links to a segmented group of ports.
•
– Configures a tunnel across one or more intermediate switches which pass
traffic for VLAN groups to which they do not belong.
Port Configuration
This section describes how to configure port connections, mirror traffic from one port to another,
and run cable diagnostics.
Configuring by Port List
Use the Interface > Port > General (Configure by Port List) page to enable/disable an interface, set
auto-negotiation and the interface capabilities to advertise, or manually fix the speed, duplex
mode, and flow control.
CLI References
•