Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 298)

248 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
IPv6 ACLs
11
permit, deny (Extended IPv6 ACL)
This command adds a rule to an Extended IPv6 ACL. The rule sets a filter condition for packets with
specific source or destination IP addresses, or next header type. Use the no form to remove a rule.
Syntax
{permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
{any | destination-ipv6-address[/prefix-length]}
[dscp dscp] [next-header
next-header]
[time-range time-range-name]
no {permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
{any | destination-ipv6-address[/prefix-length]}
[dscp dscp] [next-header
next-header]
any – Any IP address (an abbreviation for the IPv6 prefix ::/0).
host – Keyword followed by a specific source IP address.
source-ipv6-address - An IPv6 source address or network class. The address must be
formatted according to RFC 2373 “IPv6 Addressing Architecture,” using 8 colon-separated
16-bit hexadecimal values. One double colon may be used in the address to indicate the
appropriate number of zeros required to fill the undefined fields.
destination-ipv6-address - An IPv6 destination address or network class. The address
must be formatted according to RFC 2373 “IPv6 Addressing Architecture,” using 8
colon-separated 16-bit hexadecimal values. One double colon may be used in the address
to indicate the appropriate number of zeros required to fill the undefined fields.
prefix-length - A decimal value indicating how many contiguous bits (from the left) of the
address comprise the prefix; i.e., the network portion of the address. (Range: 0-128 for
source prefix, 0-8 for destination prefix)
dscp – DSCP traffic class. (Range: 0-63)
next-header – Identifies the type of header immediately following the IPv6 header.
(Range: 0-255)
time-range-name - Name of the time range. (Range: 1-30 characters)
Default Setting
None
Command Mode
Extended IPv6 ACL
Command Usage
• All new rules are appended to the end of the list.