Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 527)

Brocade 6910 Ethernet Access Switch Configuration Guide 477
53-1002581-01
MVR for IPv4
23
Related Commands
mvr profile (478)
mvr domain
This command enables Multicast VLAN Registration (MVR) for a specific domain. Use the no form
of this command to disable MVR for a domain.
Syntax
[no] mvr domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR must be
configured for an IGMP version 1 host, the multicast groups must be statically assigned using the
mvr vlan group command.
Example
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
mvr priority
This command assigns a priority to all multicast traffic in the MVR VLAN. Use the no form of this
command to restore the default setting.
Syntax
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded into the MVR VLAN.
(Range: 0-6, where 6 is the highest priority)
Default Setting
Disabled
Command Mode
Global Configuration