Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 669)

Brocade 6910 Ethernet Access Switch Configuration Guide 619
53-1002581-01
IPv6 Interface
29
ipv6 nd ns-interval
This command configures the interval between transmitting IPv6 neighbor solicitation messages
on an interface. Use the no form to restore the default value.
Syntax
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
milliseconds - The interval between transmitting IPv6 neighbor solicitation messages.
(Range: 1000-3600000)
Default Setting
1000 milliseconds is used for neighbor discovery operations
Command Mode
Interface Configuration (VLAN)
Command Usage
This command specifies the interval between transmitting neighbor solicitation messages when
resolving an address, or when probing the reachability of a neighbor. Therefore, avoid using very
short intervals for normal IPv6 operations.
Example
The following sets the interval between sending neighbor solicitation messages to 30000
milliseconds:
Console(config)#interface vlan 1
Console(config)#pv6 nd ns-interval 30000
Console(config)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled
Link-local address:
FE80::200:E8FF:FE90:0/64
Global unicast address(es):
2009:DB9:2229::79, subnet is 2009:DB9:2229:0::/64
Joined group address(es):
FF01::1/16
FF02::1/16
FF02::1:FF00:79/104
FF02::1:FF90:0/104
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 5.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
Console#
Related Commands
show running-config (59)