Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 730)

680 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Port Configuration
33
• The destination port cannot be a trunk or trunk member port.
Parameters
These parameters are displayed:
• Source Port – The port whose traffic will be monitored.
• Target Port – The port that will mirror the traffic on the source port.
• Type – Allows you to select which traffic to mirror to the target port, Rx (receive), Tx (transmit),
or Both. (Default: Both)
Interface
To configure a local mirror session:
1. Click Interface, Port, Mirror.
2. Select Add from the Action List.
3. Specify the source port.
4. Specify the monitor port.
5. Specify the traffic type to be mirrored.
6. Click Apply.
FIGURE 34 Configuring Local Port Mirroring
To display the configured mirror sessions:
1. Click Interface, Port, Mirror.
2. Select Show from the Action List.
FIGURE 35 Displaying Local Port Mirror Sessions