Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 518)

468 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
IGMP Filtering and Throttling
23
The following shows the ports in VLAN 1 which are attached to multicast routers.
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Port Type
---- ------------------ -------
1 Eth 1/10 Static
Console#
IGMP Filtering and Throttling
In certain switch applications, the administrator may want to control the multicast services that are
available to end users. For example, an IP/TV service based on a specific subscription plan. The
IGMP filtering feature fulfills this requirement by restricting access to specified multicast services
on a switch port, and IGMP throttling limits the number of simultaneous multicast groups a port
can join.
ip igmp filter (Global Configuration)
This command globally enables IGMP filtering and throttling on the switch. Use the no form to
disable the feature.
Syntax
[no] ip igmp filter
Default Setting
Disabled
Command Mode
Global Configuration
TABLE 109 IGMP Filtering and Throttling Commands
Command Function Mode
ip igmp filter Enables IGMP filtering and throttling on the switch GC
ip igmp profile Sets a profile number and enters IGMP filter profile configuration
mode GC
permit, deny Sets a profile access mode to permit or deny IPC
range Specifies one or a range of multicast addresses for a profile IPC
ip igmp filter Assigns an IGMP filter profile to an interface IC
ip igmp max-groups Specifies an IGMP throttling number for an interface IC
ip igmp max-groups action Sets the IGMP throttling action for an interface IC
show ip igmp filter Displays the IGMP filtering status PE
show ip igmp profile Displays IGMP profiles and settings PE
show ip igmp throttle interface Displays the IGMP throttling setting for interfaces PE