Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1018)

968 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Ethernet Ring Protection Switching
42
To configure the ERPS parameters for a ring:
1. Click Administration, ERPS.
2. Select Configure Domain from the Step list.
3. Select Configure Details from the Action list.
4. Configure the ERPS parameters for this node. Note that spanning tree protocol cannot be
configured on the ring ports, nor can these ports be members of a static or dynamic trunk. And
the control VLAN must be unique for each ring. Adjust the protocol timers as required. The RPL
owner must be set on one of the rings. And the administrative status enabled once all of the
other settings have been entered.
5. Click Apply.
FIGURE 282 Creating an ERPS Ring (Primary Ring)