Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1042)

992 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Connectivity Fault Management
42
• MA Index – MA identifier. (Range: 1-2147483647)
• Source MEP ID – The identifier of a source MEP that will send the delay-measure message.
(Range: 1-8191)
• Target
• MEP ID – The identifier of a remote MEP that is the target of a delay-measure message.
(Range: 1-8191)
• MAC Address – MAC address of a remote MEP that is the target of a delay-measure
message. This address can be entered in either of the following formats: xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxx
• Count – The number of times to retry sending the message if no response is received before
the specified timeout. (Range: 1-5; Default: 5)
• Packet Size – The size of the delay-measure message. (Range: 64-1518 bytes; Default: 64
bytes)
• Interval – The transmission delay between delay-measure messages. (Range: 1-5 seconds;
Default: 1 second)
• Timeout – The timeout to wait for a response. (Range: 1-5 seconds; Default: 5 seconds)
Interface
To transmit delay-measure messages:
1. Click Administration, CFM.
2. Select Transmit Delay Measure from the Step list.
3. Select an entry from MD Index and MA Index.
4. Specify the source MEP, the target MEP using either its MEP identifier or MAC address, set the
number of times the delay-measure message is to be sent, the interval, and the timeout.
5. Click Apply.