Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 373)

Brocade 6910 Ethernet Access Switch Configuration Guide 323
53-1002581-01
Automatic Traffic Control Commands
16
snmp-server enable port-traps atc multicast-alarm-clear
This command sends a trap when multicast traffic falls beneath the lower threshold after a storm
control response has been triggered. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc multicast-alarm-clear
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-alarm-clear
Console(config-if)#
Related Commands
auto-traffic-control action (317)
auto-traffic-control alarm-clear-threshold (318)
snmp-server enable port-traps atc multicast-alarm-fire
This command sends a trap when multicast traffic exceeds the upper threshold for automatic
storm control. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc multicast-alarm-fire
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-alarm-fire
Console(config-if)#
Related Commands
auto-traffic-control alarm-fire-threshold (319)